Pull Out The Viewfinder Completely; Attaching And Removing The Battery Pack - Sharp ViewCam Slim VL-AX1S Operation Manual

Attaching and Removing
the Battery Pack
Attaching
1
Make sure that the POWER switch is set
to OFF.
2

Pull out the viewfinder completely ( ),

then lift it up ( ).
60˚
3
Align the mark on the side of the
battery pack with the
camcorder ( ). Press the battery pack
and slide it down completely until it locks
into place ( ).
4
Lower the viewfinder ( ), and push it in
completely ( ).
POWER switch
mark on the
Removing
1
Make sure that the POWER switch is set
to OFF.
2
Press and hold the power source
UNLOCK release in the direction of the
arrow ( ), then slide the battery pack
up and take it out ( ).
Power source
UNLOCK release
Cautions:
• BEFORE REMOVING THE BATTERY PACK,
ALWAYS STOP RECORDING OR PLAYBACK
AND TURN THE POWER OFF. Removing the
battery pack while shooting or during playback
may damage the tape by causing it to wrap
around the video head drum or destroy the card,
rendering it unreadable and unwritable.
• Remove the battery pack from the camcorder if
you will not use the camcorder for a long period
of time.
• Make sure that the battery pack is firmly
attached during operation. If it is not, the battery
pack may come off or camcorder operation may
fall because of the poor contact pressure.
• To prevent damage to the battery pack when
removing, be sure to firmly hold the battery pack
while pressing the release.
• Use only SHARP model BT-L221, BT-L441, BT-
LS222 or BT-LS442A battery packs with this
camcorder. Use of other batteries may create a
risk of fire or explosion.
10