Table of Contents
Advertisement
Preparation
Using the Lens Cap
Attach the strap of the lens cap to the hand
strap as shown below.
When attaching or removing the lens cap,
grasp the indents on both sides of the cap.
When recording, remove the lens cap and
attach the lens cap cord to the fastener so that
the cap will not get in the way.
Fastener
Note:
• Always attach the lens cap over the lens when
not using the camcorder.
17
VL-AX1H-009-021
Adjusting the Hand
Strap
1
Open the hand strap flap (1) and the
grip strap (2).
2
Loosen the grip strap, pass your right
hand through the loop, and put your
thumb on the REC START/STOP button
Indents
and your forefinger on the Power Zoom
control. Then, pull the grip strap tight
until it fits snugly.
3
Seal the velcro fasteners of the grip
strap and the hand strap flap.
Caution:
• Do not swing the camcorder by the hand strap.
17
Power zoom control
REC START/
STOP button
01.11.1, 11:00 AM
Advertisement
Table of Contents
