Adjusting The Grip Strap; Using The Lens Cap; Attaching The Shoulder Strap - Sharp VIEWCAM VL-SD20S Operation Manual

Adjusting the Grip Strap

1
Open the hand strap flap (Q) and grip
strap (W).
2
Loosen the grip strap, pass your hand
through the loop and put your thumb
close to the Power Zoom control. Then
pull the grip strap tight until it fits snugly.
3
Seal the velcro closure of the grip strap
(Q) and close the hand strap flap (W).
Caution:
• Do not swing the VIEWCAM by the hand strap.

Using the Lens Cap

Attach the lens cap cord to the VIEWCAM as
shown below (Q), and attach the lens cap to
the lens (W).
V L - S D 2 0 S - G B / p p . 0 0 8 - 0 1 6 ; 9 9 / 8 / 1 0 / 1 8 : 0 0
When recording, remove the lens cap (Q) and
attach the lens cap cord to the fastener (W) so
the lens cap will not get in the way.
Note:
• Always replace the lens cap on the lens when
the VIEWCAM is not in use.

Attaching the Shoulder Strap

1
Hold one end of the strap and thread it
through the loop on the left side of the
LCD screen.
2
Loosen the strap in the buckle, then feed
the end of the strap through the buckle,
as shown.
3
Draw the strap in the direction of the
arrow to secure.
4–6
Use the same procedure to attach the
other end of the strap to the loop on
the lens side.
1
2
Buckle
3
G. K . A s s o c i a t e s , To k y o
Fastener
4
5
Buckle
6
12