Playback Tape Playback; Volume Control - Sharp ViewCam Slim VL-AX1S Operation Manual

Basic Operations
Playback
Tape Playback
Available mode:
TAPE-VCR
The LCD monitor screen functions as a handy
playback monitor. Nothing needs to be con-
nected, allowing instant on-screen playback
with the sound through the built-in speaker.
Operation button
1
Open the LCD monitor and
adjust the angle, and then
set the Media Selection
switch to TAPE.
2
Hold down the Lock button
and set the POWER
switch to VCR.
3
Press (or
button to rewind (or fast forward) the
tape to the desired point.
4
Press to begin playback.
Note:
• If you press the REC START/STOP button in
TAPE-VCR mode, the
and the camcorder enters Recording
Standby mode. If you do not intend to
record, press
then press to begin playback. This will
ensure your previous recording is not
erased.
Media Selection switch
POWER switch
Lock button
) on the Operation
mark appears
to turn the mark off,
To stop playback
Press .
To turn the power off
Set the POWER switch to OFF without pressing
the Lock button.
Note:
• The tape is automatically rewound when
playback reaches the end of the tape.
Watching the Playback in the
Viewfinder
You can also watch the playback in the
viewfinder by closing the LCD monitor with the
screen facing in. You cannot monitor the sound
through the speaker when watching the
playback in the viewfinder.

Volume Control

Available mode:
TAPE-VCR
When the camcorder is in TAPE-VCR mode,
push the Volume control to the
increase ( ) or decrease ( ) the volume.
The volume level indicator will appear on the
LCD screen during adjustment only. Once the
Volume control is released, the volume level
indicator will disappear shortly.
Volume control
Decrease
or side to
VOLUME
Increase
26