Installing The Lithium Batteries - Sharp ViewCam Slim VL-AX1S Operation Manual

Installing the Lithium
Batteries
Installing the Memory Battery
One of the supplied lithium batteries is used to
store the memory of the date and time settings.
1
Press the LCD monitor PUSH OPEN
release and open the LCD monitor.
2
Open the lithium battery compartment
door using a pointed object such as the
tip of a ballpoint pen.
3
Insert the lithium
battery into the
compartment with the
side of the battery
facing out.
4
Place the compartment door, and close
it firmly until it clicks into place.
5
Close the LCD monitor until it clicks into
place.
Removing the lithium battery
Perform steps 1 and 2
above, then lift up the battery
using a pointed object, and
take it out.
Lithium battery
compartment door
Installing the Battery to Re-
mote Control
Another supplied lithium battery is used to
power the remote control unit.
1
Hold the remote control
facing down, and pull
out the battery holder
while pressing the tab
toward the centre.
2
Insert the lithium battery into the battery
holder with the
facing the side of the holder.
3
Insert the battery holder back into
position.
Notes on the Use of the Lithium battery
CAUTION: Danger of explosion if battery is
incorrectly replaced. Replace only with the
same or equivalent type CR2025 recom-
mended by the equipment manufacturer.
KEEP THIS BATTERY AWAY
FROM CHILDREN. IF SWALLOWED,
CONSULT A PHYSICIAN IMMEDIATELY FOR
EMERGENCY TREATMENT.
BATTERY MAY EXPLODE IF
MIS-USED OR INSTALLED WITH POLARITY
REVERSED. DO NOT RECHARGE, DISAS-
SEMBLE OR DISPOSE OF IN FIRE.
• Do not short-circuit, recharge, disassemble, or
heat the lithium battery.
• Should the lithium battery leak, wipe the
battery compartment clean, and then insert a
new battery.
• The lithium battery will last about one year
under normal usage.
Tab
side of the battery
side
mark
14