Resetting The Lamp Operating Time - Epson EMP-30 User Manual

Maintenance

Resetting the Lamp Operating Time

The projector has a built-in counter which keeps track of the lamp operating time. When the cumulative
operating time reaches a certain point, it causes the replacement warning message to be displayed. Therefore,
the counter needs to be reset after the lamp has been replaced with a new one. You can do this using the
configuration menu.
Procedure
1
2
3
4
48
Install the lamp securely. If the lamp cover is removed, the lamp turns off automatically as a
safety precaution. Moreover, the lamp will not turn on if the lamp or the lamp cover is not
installed correctly.
Spare lamps are provided with a spare air filter. The air filter should also be replaced when the
lamp is replaced. (p.49)
Dispose of used lamps properly in accordance with your local regulations.
Do not reset the lamp operating time except after the lamp has been replaced, otherwise the lamp
replacement period will not be indicated correctly.
Projector
Remote control
Menu A/V Mute Freeze
E-Zoom
Enter
:
Lamp 1400H
:
Reset Lamp Timer Execute
:
Video Source Computer
:
Input Signal RGB
:
Frequency H ---.--kHz
:
V ---.--Hz
:
SYNC Polarity H ------
: V ------
SYNC Mode : ------
:
Resolution --- x---
:
Refresh Rate ---.--Hz
Reset Lamp Timer
Execute?
YES NO
Connect the power cable, and then
press the [Power] button on either the
projector's control panel or the remote
control to turn on the power for the
projector.
Press the [Menu] button on the remote
control.
The configuration menu will be displayed.
Select "Reset Lamp Timer" from the
"About" menu and then press the
[Enter] button.
Select "Yes" and then press the [Enter]
button.
The lamp operating time will then be reset.