Adjusting the Screen Image
Adjusting the Image Angle
The projector should be set up so that it is as perpendicular to the screen as possible.
Seen from the side
9.6
Centre of
lens
1
If it is not possible to set up the projector so that it is perpendicular to the screen, it can be set up at a slight
vertical angle instead. You can extend or retract the front adjustable feet to adjust the projection angle within
a maximum range of 10º.
Procedure
12
Foot adjust buttons
(side)
When the foot is adjusted, it may cause the projected images to become distorted. Use the
keystone correction function to adjust this distortion. (p.13)
If the projector is tilted horizontally, turn the bases of the front adjustable feet to adjust the angle.
Front adjustable
foot
Extend
Retract
Seen from above
While pressing the two foot adjust
buttons at either side, lift up the front of
the projector so that the front
adjustable feet can extend.
Extend the front adjustable feet until the desired
angle is obtained, and then release the foot adjust
buttons.
To retract the front adjustable feet, gently push
down on the projector while pressing the two foot
adjust buttons.