When Having Some Trouble; (Warning) Indicator - Epson EMP-30 User Manual

When Having Some Trouble

If you are having a problem with the projector, first check the projector's indicators.
The projector is provided with the following two indicators. These indicators alert you to problems with projector
operation.
Power indicator
The following tables show what the indicators mean and how to remedy problems that they indicate.

(Warning) Indicator

Status
Red
Red
(0.5-second
intervals)
Warning indicator
Cause
High internal The lamp will turn off automatically and projection will
temperature stop. Wait for about 5 minutes without operating the
(overheating) projector. After about 5 minutes have elapsed, unplug the
power cable and then check the following two points.
Check that the air inlet and air outlet are clear, and that
the projector is not positioned against a wall.
If the air filter is dirty, it should be cleaned.
When the power cable is plugged back in, the projector
will return to its previous state, so press the [Power] button
on either the projector's control panel or the remote
control to turn it back on. If the projector continues to
overheat even after the above points have been checked, or
if the indicators show a problem when the power is turned
back on, stop using the projector, disconnect the power
cable from the electrical outlet, and contact your dealer or
the nearest address provided at "International Warranty
Conditions" in Safety Instructions/World-Wide Warranty
Terms.
Problem with Disconnect the power cable from the electrical outlet and
lamp then remove the lamp and check if it is broken. If the lamp
is not broken, reinstall it. Then reconnect the power cable
and press the [Power] button on either the projector's
control panel or the remote control to turn the power back
on.
If the indicators still show a problem, stop using the
projector, disconnect the power cable from the electrical
outlet, and contact your dealer or the nearest address
provided at "International Warranty Conditions" in Safety
Instructions/World-Wide Warranty Terms.
If the lamp is broken replace by a new lamp, or contact
your local dealer for further advise. If replacing the lamp
yourself, be careful to avoid pieces of broken glass.
(Projection cannot be carried out until the lamp is
replaced.)
Check that the lamp and the lamp cover are securely
installed. If the lamp or lamp cover is not securely
installed, the lamp will not switch on.
Power Indicator
Remedy or Status

(Warning) Indicator

: lit : flashing
See Page
Setup Guide
p.44
p.46
p.46
p.46
33