Power Indicator - Epson EMP-30 User Manual

When Having Some Trouble
Status
Red
(1-second
intervals)
Orange

Power Indicator

Status
Orange
Orange
Green
Green
34
Cause
Internal problem Stop using the projector, disconnect the power cable from
the electrical outlet, and contact your dealer or the nearest
address provided at "International Warranty Conditions"
in Safety Instructions/World-Wide Warranty Terms.
High-speed (This is not an abnormality, but if the temperature rises too
cooling in high again, projection will stop automatically.)
progress Set the projector up in a place which is well-ventilated,
and so that the air filter and exhaust vents are clear.
Clean the air filter.
Cause
Standby status (Not abnormal)
The power cable should only be disconnected when the
projector is in this condition.
Press the [Power] button to start projection.
Cool-down in (Not abnormal)
progress Please wait.
The cool-down
The [Power] button does not work during cool-down.
Press the button again after cool-down ends.
Projection in (Not abnormal)
progress
Warm-up in (Not abnormal)
progress Please wait.
Warm-up time is approximately 40 seconds.
After warm-up is complete, the flashing green indicator
changes to steady green.
If the projector is not operating properly even though the indicators are all showing normal, refer
to "When the Indicators Provide No Help" on the following page.
If an indicator is showing a status which does not appear in the previous tables, contact your
dealer or the nearest address provided at "International Warranty Conditions" in Safety
Instructions/World-Wide Warranty Terms .

Power Indicator

Remedy or Status
Remedy or Status
period lasts for about 20 seconds.
(Warning) Indicator
See Page
Setup Guide
p.44
: lit : flashing
See Page
p.6
p.9
p.7
p.7