Epson EMP-30 User Manual page 40

When the Indicators Provide No Help
Has the computer been set for dual display?
(When connected to a computer)
Has the image brightness been adjusted
correctly?
Are the cables connected correctly?
Are the image signal format settings correct?
If the "Input Signal" menu command is set to
"YCbCr" or "YPbPr" when a computer is connected,
the projected images will appear purplish.
If the "Input Signal" command is set to "RGB" when
a component video signal source is connected to the
projector, the images will appear greenish.
Has the image contrast
correctly?
Has the colour been adjusted correctly?
Have the colour intensity and tint been
adjusted correctly?
(The colours may not exactly match the colours in
the image on the computer screen or LCD screen,
but this is normal and is not the sign of a problem.)
Is the lamp due for replacement?
When the lamp is nearly due for replacement, the
image will become darker and the colour quality
will become poorer.
The accessory EPSON cinema filter has
been removed from the lens, but the
"EPSON Cinema Filter" command in the
"Video" menu is still set to "ON".
38
Probable cause
Probable cause
been adjusted
If dual display has been activated in the Display
Properties of the connected computer's Control
Panel, the projector will only display about half of
the image on the computer screen. To display the
whole of the image on the computer screen, turn off
the dual display setting. Refer to the video driver
manual for the computer's monitor for further
details.
Condition
The image colours are not right
Use the "Brightness" command to adjust.
"Video" - "Brightness" (p.20, 22)
Check that all cables that are required for projection
are connected correctly. (Setup Guide)
If a component video , RGB video or computer
source is connected to the projector, use the "Input
Signal" command to select the signal format which
matches the signal connected source.
"Video" - "Input Signal" (p.21, 22)
If a composite video
connected to the projector, use the "Video Signal"
command to select the video signal format.
"Video" - "Video Signal" (p.21)
Use the "Contrast" command to adjust.
"Video" - "Contrast" (p.20, 22)
Use the "Color Adjustment" command to adjust the
contrast.
"Advanced" - "Color Adjustment" (p.24)
Use the Video menu to adjust the Color and Tint
settings
"Video" - "Color", "Tint" (p.20, 21)
When this happens, the lamp should be replaced
with a new one. (p.46)
Change the "EPSON Cinema Filter" setting in the
"Video" menu to "OFF".
"Video" - "EPSON Cinema Filter" (p.20, 22)
Remedy
Remedy
or S-Video source is