Setting Up the Projector
22
After the software has been installed, you see your computer's
desktop displayed by the projector. You can switch the projector
to other image sources using the
control, and then switch back to your desktop display by pressing
.
EasyMP
6. See Chapter 2 for instructions on displaying and adjusting the
image.
7. When you're done projecting from your computer, disconnect
the USB cable.
Connecting to the BNC Connectors
1. Obtain a commercially available standard BNC to VGA video
cable.
2. Plug the BNC connectors into the projector's
connectors as shown below. Depending on your
R/Cr/Pr
computer's video card, you may have to connect to the projector's
and
V Sync
H/C Sync
documentation for more information.)
3. Plug the VGA connector on the other end of the cable into your
computer's monitor port.
buttons on the remote
Source
connectors too. (See your computer
,
, and
B/Cb/Pb
G/Y