Setting The Projector Id - Epson EB G5200WNL User Manual

Operating Two or More Projectors With
the Remote Control
If you're using more than one projector, you can control all the
projectors—or just selected ones—by using the projector ID system.
To operate a projector, set the remote control's ID to match that of
the projector. Or you can control all the projectors at once by setting
the remote control's ID to zero.

Setting the Projector ID

The projector's default ID is set to Off. This lets it respond to
commands from any remote control. To change the ID, follow these
steps:
1. Press the button on the remote control. You see the
Menu
projector's menu screen.
2. Select , then
Extended
3. Use the pointer button to highlight the new ID, and press
to select it.
Enter
4. When you're done, press
.
Projector ID
to exit.
Menu
Presenting With the Remote Control
57