Connecting To The Bnc Connectors - Epson PowerLite 7800p User Manual

Connecting to the BNC Connectors

1. Obtain a commercially available standard BNC cable.
2. Plug the BNC connectors into the projector's
connectors as shown below. Depending on your
R/Cr/Pr
computer's video card, you may have to connect to the projector's
and
V Sync H/C Sync
documentation for more information.)
G/Y
B/Cb/Pb
3. Plug the connectors on the other end of the cable into the BNC
video out connectors on your computer.
4. Optionally, you can connect an external monitor (see page 23),
play sound through the projector (see page 24), or connect a USB
cable to use the remote control as a mouse (see page 22).
5. When you've finished making any connections, see Chapter 2 for
instructions on turning on the projector and adjusting the image.
Once the projector is turned on, be sure to:
Enter the projector's Setting menu, then make sure the BNC
■
Input is set to
After exiting the menu system, press the
■
the remote control or repeatedly press the
on the projector's control panel to select the correct source
(
BNC (Analog-RGB)
connectors too. (See your computer
R/Cr/Pr
. See page 72.
Analog-RGB
should appear on the screen).
, , and
B/Cb/Pb G/Y
button on
BNC
button
Video/BNC
Setting Up the Projector
BNC cable
19