Solving Projector Operation Problems; Solving Problems With The Image Or Sound - Epson EB G5200WNL User Manual

Solving Projector Operation Problems

The power doesn't turn on.
■ If the projector doesn't turn on when you press the Ppower
button, make sure the power cord is connected to the projector
and plugged into a working electrical outlet.
The power cord may be defective. Disconnect the cord from the
■
outlet and contact Epson as described on page 146.
If you're using the Direct Power On function and you
■
immediately plug the power cord back in after unplugging it, the
power may not turn back on. Press the Ppower button to turn
the projector back on.
The buttons on the projector don't work.
If the Control Panel Lock function has been enabled, you can't use the
buttons on the projector. Try using the remote control instead (make
sure it is set to the correct ID). See page 106 for information about the
Control Panel Lock function.
Solving Problems With the Image
or Sound
No image appears on the screen.
■ Check that the Ppower light is green, not flashing.
■ The projector may be in standby or sleep mode. If the Ppower
light is orange, press the Ppower button to turn the projector on.
■ If the power was switched off and then on again, the projector
may be cooling down. Wait until the Ppower light stops flashing
and remains orange; then press the Ppower button again.
Press the
■ A/V Mute
the picture has not been turned off temporarily.
button on the remote control to make sure
Solving Problems
137