Audio And Video Signal Flow - Yamaha DSP-Z11 Owner's Manual

Audio and video signal flow

■ Audio signal flow
Input
HDMI
DIGITAL AUDIO
(COAXIAL)
DIGITAL AUDIO
(OPTICAL)
AUDIO
Notes
• 2-channel as well as multi-channel PCM, Dolby Digital and DTS signals
input at the HDMI input jacks can be output at the HDMI OUT jacks only
when "Support Audio" is set to "Other" (see page 94).
• The following types of audio signals can be only input at HDMI input
jacks:
– DSD
– Dolby TrueHD
– Dolby Digital Plus
– DTS-HD Master Audio
– DTS-HD High Resolution Audio
■ Video signal flow
Output
COMPONENT
y
You can deinterlace and convert the resolution of the video signals by using
"Video" parameters. See page 89 for details.
Notes
• When the analog video signals are input at the COMPONENT VIDEO, S
VIDEO and VIDEO jacks, the priority order of the input signals is as
follows:
1. COMPONENT VIDEO
2. S VIDEO
3. VIDEO
• This unit is equipped with the two COMPONENT VIDEO MONITOR
OUT jacks and HDMI OUT jacks. The COMPONENT VIDEO
MONITOR OUT 1 and 2 outputs the same video signals and you can use
both COMPONENT VIDEO OUT jacks simultaneously.
• Digital video signals input at the HDMI input jacks cannot be output from
analog video output jacks.
• The analog component video signals (with 480i (NTSC)/576i (PAL) of
resolution only) are converted to the S-video or composite video signals
and output at the VIDEO or S VIDEO MONITOR OUT jacks.
• The GUI signal is not output at the DVR OUT and
VCR OUT jacks and is not recorded.
Input
HDMI
VIDEO
S VIDEO
VIDEO
Through
"Conversion": "On" (see page 89)
Connections
Output
29
En