Saved Parameters For The Main Zone; Saved Parameters For Zone 2, Zone 3, Or Zone 4; Loading The Stored System Settings; Loading By The System Memory Buttons - Yamaha DSP-Z11 Owner's Manual

Saving and recalling the system settings (System Memory)

■ Saved parameters for the main zone

The groups of the system parameters indicated in bold are the
groups that is saved in the initial setting.
Group
Input/HDMI Audio Select
*
Out
Decoder Mode
Input source
HDMI OUT SEL
Audio Stereo/Surround
Pure Direct on/off
EXTD SUR. setting
Adaptive DRC
Adaptive DSP Lvl
LFE Level
Dynamic Range
Tone Control
Pure Direct
CINEMA DSP HD³ ON/OFF
Volume Volume level
SP Config S-Wave Control
Parametric EQ
THX Set
Speaker Set
Speaker Distance
Speaker Level
Speaker B
Information (Auto Setup)
Setup Menu (Auto Setup)
Selected front speaker set (A and/or B)
Video Conversion
HDMI Processing
Component I/P
HDMI Resolution
HDMI Aspect
Short Message
On Screen
Position
Wall Paper
Option Lipsync
Front Panel Disp.
Support Audio
Note
* The playing status of the network/USB sources (selected radio station, etc.) is also
saved.
98
En
Parameters

■ Saved parameters for Zone 2, Zone 3, or Zone 4

Parameter
Input
Page
Volume
82
Tone Control
82
50
Note
—
* The playing status of the network/USB sources (selected radio station,
77
etc.) is also saved.
61
72

Loading the stored system settings

86
• Before performing the following operations, set the operation mode selector on
86
the remote control to F AMP.
86
• This unit overwrites the stored settings to the current settings of this unit. If you
do not want to erase the current settings, save the current settings to any System
87
Memory number in advance.
88
■ Loading by the
89
You can recall the system settings stored in "Memory1" to
60
"Memory4" by pressing the corresponding 7SYSTEM MEMORY
50
buttons.
87
y
87
To recall the system settings for Zone 2, Zone 3, or Zone 4, press HZONE on the
remote control repeatedly to select the operation zone setting of the remote control in
83
advance. You can recall the system settings for the selected zone only when the zone is
turned on.
84
85
Press one of the 7SYSTEM MEMORY buttons on
1
86
the remote control to select the desired memory
91
number.
"MEMORY 1 LOAD" (example) appears in the front panel
45
display.
44
y
51
"EMPTY" appears in the menu screen if no system settings are stored in the
89
selected memory number.
90
Press the selected 7SYSTEM MEMORY button
2
90
once more to confirm the selection.
90
This unit loads the settings stored in the selected memory
90
number.
90

■ Loading by the GUI menu operation

90
90
Press I MENU on the remote control.
1
91
The top menu appears in the video monitor.
88
2
Press 9k / n repeatedly to select "System Memory"
93
and then press 9h.
94
The "System Memory" menu appears in the video monitor.
3
Press 9k / n repeatedly to select the desired zone
and then press 9h.
In the following example, you select "Main" (main zone). The
list of the memory number appears in the video monitor.
Descriptions
Input source *
Volume level
Tone control settings
SYSTEM MEMORY buttons
7
Main Load Memory1
Main Save Memory2
Main Rename Memory3
Page
117
117
117