Connections; Connecting Audio/Video Source Equipment To This Unit - Yamaha DSP-A1 Owner's Manual

Never plug in this unit and other components until all connections are completed.
When making connections between this unit and other components, be sure all connections are made correctly, that is to say L (left)
to L, R (right) to R, "+" to "+" and "–" to "–". Also, refer to the owner's manual for each component to be connected to this unit.

CONNECTING AUDIO/VIDEO SOURCE EQUIPMENT TO THIS UNIT

For connections with audio/video units, use RCA type pin plug cables with the exception described later.
* If you have YAMAHA audio/video units numbered as 1, 2, 3, etc. on the rear panel, connections can be made easily only by
connecting the output (or input) terminals of each unit to the same-numbered terminals of this unit.
BASIC CONNECTIONS (for Audio Units)
Tuner
MD recorder,
Tape deck 1, etc.
Tape deck 2
1
:
*
GND terminal (For turntable use)
Connecting the ground wire of the turntable to the GND
terminal will normally minimize hum, but in some cases
better results may be obtained with the ground wire
disconnected.
10

CONNECTIONS

1
*
OUTPUT
LINE OUT
LINE IN
LINE OUT
LINE IN
Turntable
DIGITAL AUDIO SIGNAL
(AC-3) RF SIGNAL
GND
LD PHONO
1
CD
CD
2
TV/DBS
TUNER
3
DVD/
VCR 3 PLAY
COAXIAL
MD/TAPE 1
OPTICAL
4
CD
REC
3
PLAY
PLAY
MD/TAPE 1 TAPE 2
4
REC
REC
LD
MAIN
SUB
TV/DBS
WOOFER
DVD/
SURROUND
VCR 3
DIGITAL SIGNAL EXTERNAL DECODER INPUT
CD player
(General model)
AUDIO SIGNAL VIDEO SIGNAL
VIDEO S VIDEO
LD
TV/DBS
IN
VCR 1
OUT
IN
VCR 2
OUT
IN
DVD/
VCR 3
OUT
MONITOR
CENTER
OUT
MAIN
FRONT
DVD/VCR 3 OUT
CAN BE USED AS A SECOND
MONITOR OUT, IF SELECTED
BY SET MENU.
PAL NTSC