Connecting The Network; Connecting The Usb Storage Devices To The Usb Ports - Yamaha DSP-Z11 Owner's Manual

Connecting the network

To connect this unit to your network, plug one end of a network cable (CAT-5 or higher straight cable) into the NETWORK port on this unit,
and plug the other end into one of the LAN ports on your router that supports the DHCP (Dynamic Host Configuration Protocol) server
function. The following diagram shows a connection example where this unit is connected to one of the LAN ports on a 4-port router. To
enjoy music files saved on your PC and Yamaha MCX-2000, access the Internet Radio, or control this unit by using your PC, each device
must be connected properly in the network.
Notes
• You must use an STP (shielded twisted pair) cable (commercially available) to connect a network hub or router and this unit.
• If the DHCP server function on your router is disabled, you need to configure the network settings manually (see page 92).
• Yamaha MCX-2000, MCX-A10 and MCX-C15 may not be for sale in same locations.
Internet
Modem
Router
Network cable

Connecting the USB storage devices to the USB ports

This unit is equipped with both the front and rear USB ports. Connect the USB storage device (for example, a high capacity USB hard disk
drive) to the front or rear USB port on this unit. Set "USB Select" in "Input Select" to "Front" or "Rear" to select the active USB port (see
page 83). The initial setting of "USB Select" is "Front". The initial setting of "USB Select" is "Front".
(Rear panel)
Notes
• We do not guarantee the power supply and operation of all the connected USB devices.
• See page 69 for more information about the USB storage devices that this unit is supported to.
Yamaha MCX-2000
WAN
LAN
NETWORK
USB
USB storage device
Yamaha MCX-C15
Yamaha MCX-A10
(with optional
speakers)
T/
2 TONE CONTROL
PUSH ENTER
L
HDMI IN USB
USB storage device or USB
portable audio player
Connections
PC
(Front panel)
37
En