Never plug in this unit and other components until all connections are completed.
When making connections between this unit and other components, be sure all connections are made correctly, that is to say L (left)
to L, R (right) to R, "+" to "+" and "–" to "–". Also, refer to the owner's manual for each component to be connected to this unit.
CONNECTING AUDIO/VIDEO SOURCE EQUIPMENT TO THIS UNIT
For connections with audio/video units, use RCA type pin plug cables with the exception described later.
* If you have YAMAHA audio/video units numbered as 1, 2, 3, etc. on the rear panel, connections can be made easily only by
connecting the output (or input) terminals of each unit to the same-numbered terminals of this unit.
BASIC CONNECTIONS (for Audio Units)
Tape deck 1, etc.
Tape deck 2
GND terminal (For turntable use)
Connecting the ground wire of the turntable to the GND
terminal will normally minimize hum, but in some cases
better results may be obtained with the ground wire
(AC-3) RF SIGNAL
EXTERNAL DECODER INPUT
DVD/VCR 3 OUT
CAN BE USED AS A SECOND
MONITOR OUT, IF SELECTED
BY SET MENU.