note
Macintosh configurations
vary. See your computer
manual for the location of the
ports needed to connect your
projector.
You cannot currently use the
EMP Link V software with a
Power Macintosh G3, G4, or
iMac. Check with your
dealer for future support.
Setting Up the Projector
24
Connecting to a Desktop Macintosh
To connect the projector to your desktop Macintosh, you need to:
Connect the computer video cable and computer monitor cable
I
Connect the mouse and/or serial cable (if you want to use the
I
remote control as a mouse or use the EMP Link V software)
Connect the audio cable (if you'll be projecting with audio)
I
Follow the steps in each section for the cables you need to connect.
Before beginning, turn off the projector and computer if they are on.
Connecting the Video and Monitor Cables
This illustration shows the connections you'll be making. (You may
not need to use the adapters as shown.) For details, follow the steps
below.
Macintosh
desktop
adapter (if
needed)
Computer 1
(VGA) port
Monitor Out
port
Macintosh monitor
adapter (if needed)
1. Disconnect the monitor cable from the video port on the back of
the Macintosh.
2. Connect one end of the computer video cable to the projector's
(VGA) port, as shown.
Computer 1
computer
video cable
Macintosh
monitor cable