Problems With The Remote Control - Epson PowerLite 8200i User Manual

Power
Freeze
A/V Mute
R/C ON ON/OFF
E-Zoom
OFF
switch
3
Enter
Esc
Solving Problems
86
The temperature light is flashing orange.
The projector is too hot. Press the
it cool for 5 minutes before using it again.
The temperature light is flashing red.
The cooling fan or temperature sensor is not working correctly and
the projector is too hot. Turn it off, unplug it, and contact EPSON.

Problems with the Remote Control

The projector doesn't respond to remote control commands.
Make sure the remote control is turned on.
I
Make sure you are within 30 feet of the projector, and within
I
range of the infrared receivers (approximately 30
right and 15 ° above or below).
The remote control batteries may not be installed correctly or may
I
be low on power. Check the installation or replace them as
described on page 12.
Dim the room lights and turn off any fluorescents. Make sure the
I
projector is not in direct sunlight. Strong lighting, especially
fluorescent lights, may affect the projector's infrared receivers.
I Turn off any nearby equipment that emits infrared energy, such
as a radiant room heater.
You can't control the mouse pointer with the remote
control.
Make sure the mouse cable is securely connected to both your
I
computer's mouse port (using the main cable) and the projector's
mouse port. See Chapter 1 for details.
I Make sure you have used the correct cable. The PS/2 mouse cable
and Macintosh mouse cable look the same, but they are not
identical. Check the label on the end of the cable.
button to turn it off and let
Power
° to the left or