Remote Control Information - Epson PowerLite 8200i User Manual

Remote Control Information

You can operate the projector by remote control via a line-of-sight
infrared (IR) receiver at the front and rear of the projector. The
projector may not respond to remote control commands under the
following conditions:
There is an object between the remote control IR emitter and the
I
IR receiver on the projector.
Ambient light is too bright.
I
Certain types of fluorescent lighting are used.
I
I A strong light source shines into the IR receiver.
Other equipment that emits infrared energy, such as a radiant
I
room heater, is in the room.
These conditions commonly cause problems for most
infrared-controlled equipment. Try the following:
The remote control batteries may be low on power; replace them.
I
Dim the ambient lighting and/or turn off any fluorescent lights.
I
I Close any window coverings and/or move the projector out of
direct sunlight.
I Turn off other equipment that emits infrared energy.
If the remote control still does not work properly, remember you can
always control your computer-based presentation directly from the
computer, even in an environment containing one of the conditions
listed above.
Notices
105