Epson PowerLite 8200i Quick Setup

Locate everything
you'll need
For most setups, you'll need just these two cables:
power cord
You won't need to install any software.
Connect the projector
to your laptop
1
Make sure your projector and laptop are turned off.
2
Connect one end of the computer video cable to the
Computer 1 (VGA) port on the projector.
3
Connect the other end to your laptop's video or
®
to your PowerBook , you may need to use an adapter. See your User's Guide for instructions.
Plug in your projector
Connect the power cord to your projector and plug the other end into a grounded outlet.
Turn on your equipment
1
Remove the lens cap.
2
Press the red Power button on the projector to turn it on.
The power light flashes green as the projector warms up,
and the projection lamp comes on in about 30 seconds.
3
Turn on or restart your laptop. (Windows
this Add New Hardware screen, click Cancel.)
computer video cable
monitor port. If you can't connect the cable
® only: If you see
Caution: Before unplugging the projector...
To shut the projector down properly, press the red Power button twice. Let the
projector cool while the
stops flashing and stays on, it's safe to unplug the projector.
Never unplug the projector when the
EPSON ® PowerLite
Quick Setup
Follow these instructions to connect the projector to your laptop.
To connect other devices – such as a VCR or desktop PC – and to
use the remote control, see your User's Guide.
power light flashes orange (about a minute). Once the light
® 8200i /9100i
power light
power button
power light is green or flashing orange.
Turn over