Shutting Down The Projector - Epson PowerLite 8200i User Manual

note
When the projector has not
received any input signals for
30 minutes, it automatically
turns off the projector lamp
and enters "sleep mode." This
conserves electricity, cools the
projector, and extends the life
of the lamp. If you are done
using the projector, unplug
the power cord. If you want
to start projecting again, press
the button.
Power
caution
To avoid damaging the
projector or lamp, never
unplug the power cord
when the power light is
green or flashing orange.
Using the Projector
58

Shutting Down the Projector

When you've finished using the projector, follow the recommended
procedure to shut it down. This extends the life of the lamp and
protects the projector from possible overheating.
1. If you've connected a computer or laptop and it's displaying only
through the projector (the computer's monitor is disconnected or
turned off), shut down the computer first; otherwise you won't be
able to see your computer's display if you try turning it off after
the projector.
2. To turn off the projector, press the red
projector or remote control. You see a confirmation message. (If
you don't want to turn it off, press any other button.)
3. Press the button again. The power light flashes orange for
Power
about a minute as the projector cools down. When the projector
has cooled, the orange light stays on and the exhaust fan shuts off.
If you want to turn the projector on again, wait until the orange
light stops flashing. Then press the
4. Replace the lens cap and unplug the power cord.
5. If you're using a VCR or other video source, turn it off after you
turn off the projector.
6. Disconnect all equipment, and store the projector in a protective
case.
button on the
Power
button.
Power