Attaching Doors - Craftsman 113.198411 Operator's Manual

Front Skirt
Rear Skirt
Suppo_
/
g
Fig. 58
Angled End Of Lower Support
44. Put two truss head bolts through the rear
skirt and the upper support. Make sure the
heads of the bolts point down. Put a lock-
washer and hex nut on each bolt and tighten
using a 7/16 inch wrench or socket.
45. Put two truss head bolts through the front
support, upper support, and front skirt. Make
sure the heads of the bolts point down. Put a
lockwasher and hex nut on each bolt and
tighten using a 7/16 inch wrench or socket.
46. Tilt the cabinet back and put two truss
head bolts through the front support and the
angled end of the lower support. Put a lock-
washer and hex nut on each bolt and hand-
tighten.
Attaching Doors
oor
Magnetic Catch
/
Magnetic Stop Plate
Fig. 59 - Parts for Door Assembly
1. Lay the two doors side by side.
2. Put a magnetic catch on the inside edge of
each door. (Figure 60)
Doors
\
Magnetic Catches
Fig. 60
3. Fasten using four pan head screws. Tighten
with a Phillips screwdriver. (Figures 60 & 61)
Fig. 61 - Pan Head Screw
4. Attach a rnagnetic stop plate to the two
small holes on each side of the front support
using four pan head screws. Tighten with a
Phillips screwdriver. (Figures 62 & 63)
Front Support
O
o
/ Magnetic Stop Plate
Pan Head Screw
Fig. 62
24