Craftsman 113.198411 Operator's Manual page 49

Guard
Antikickback Pawls
Spreader
Fence
Table
/
Fig. 127
12. If the spreader and blade both rest against
the fence, no adjustment is needed. (Figure
128-A) Go to step 17, or
If the spreader is in front of the fence but not
touching it (Figure 128-B), go to step 13, or
If the spreader hits the top of the fence
(Figure 128-C), go to step 13.
A- Right
Pawl
FenC_a_l e
-Spreader
Saw Blade
13. Loosen both nuts on the spreader using a
1/2 inch wrench.
14. Slide the spreader with your hand until it
is against the fence directly behind the blade.
15. Tighten both nuts using a 1/2 inch
wrench. Do not move the spreader as you
tighten these nuts.
16. Check the blade and spreader again to
make sure that they are both against the
fence. If not, go back to step 13 and repeat.
17. Once the blade and spreader are in line,
raise the spreader up to the guard and tighten
the wing screw to hold it in place.
18. Unlock the rip lock.
19. Pull the motor forward so that the blade is
away from the fence and lock the rip lock.
20. Unlock the swivel lock.
21. Turn the motor to the crosscut positon
with the blade and arm perpendicular to the
fence.
22. Lock the swivel lock
B - Wron(
Pawl
Fence _ -Spreader
T-able I
Saw Blade
Fig. 128 - A,B,C
C - Wrong
Pawl-._ (
Fence
Table
"'Spreader
Saw Blade
49