Putting Drawers Together; Building The Cabinet - Craftsman 113.198411 Operator's Manual

37. Tighten all screws, except those on the
front and rear skirts, using a 7/16 inch wrench
or socket.
Putting Drawers Together
The following parts are used to assemble the
drawers in model 113.198611:
A.
B.
C.
D.
E.
F.
G.
H.
I.
J.
10 inch Drawers .................. 2
6 inch Drawers ................... 2
3 inch Drawers ................... 2
10 inch Drawer Fronts ............. 2
6 inch Drawer Fronts .............. 2
3 inch Drawer Fronts .............. 2
Center Slide Brackets ............ 12
Stand Slide Brackets ............. 12
Grease Packets ................... 2
_Drawer Fastener .................... 48
Note: The center slide brackets and stand
slide brackets have already been put together
in the Finishing the Cabinet section.
D,E,F I
Fig. 44 - Parts for Drawer Assembly
1. Find the six metal drawers and plastic
drawer fronts.
2. Slide the drawer fronts onto the drawers.
Make sure that the tabs on the plastic drawer
fronts slide over the metal drawers to help
hold them in place. (Figure 45)
Tab
Drawer Front
Drawer
Fig. 45
3. Push a plastic drawer fastener into each of
the holes to hold the drawers together.
(Figure 45)
4. Put the drawers aside. Do not put the
drawers into the cabinet until after you mount
the saw.
Model 113.198411
Building the Cabinet
1. The following parts are used in the cabinet
assembly for model 113.198411:
A°
B.
C.
D.
E.
F.
G.
H.
I.
J.
K.
L.
M
Right Side Panel .................. 1
Left Side Panel ................... 1
Shelf ............................ 1
Under Support ................... 1
Skirts ............................ 2
Front Shelf Stiffener .............. 1
Corner Brackets .................. 4
Lower Support ................... 1
Spacers .......................... 2
Upper Support ................... 1
Front Support .................... 1
Doors ........................... 2
Rear Shelf Stiffener ............... 1
19