Craftsman 113.198411 Operator's Manual page 20

I G
G
F
Fig. 46 - Cabinet Assembly - 113.198411
1. Turn the shelf upside down on the floor.
The wide edge should point down, and the
three narrow edges should point up.
(Figure 47)
Fig. 47
8
Lower Support
Angled End Of
Lower Support
2. Place the front shelf stiffener inside and
against the front edge of the shelf so that all
six holes line up. (Figure 47)
3. Place the under support on the shelf so that
the two holes on one end line up with the
center holes on the other two parts.
(Figure 47)
2O
4. Place the lower support under the shelf. It
should rest directly below the under support,
with the angled end sticking out. Line up the
four holes in these three pieces. (Figure 47)
Note: The angled end of the lower support is
a useful way to tell the front of the cabinet
from the back. The angled end is at the front
of the cabinet.
5. Place the rear shelf stiffener on the shelf so
that the two ends fit beween the edges of the
shelf, and the two center holes line up with
the holes at the end of the under support.
(Figure 47)
6. Put truss head bolts through the eight
holes indicated. Put a lockwasher and hex nut
on each bolt and tighten using a 7/16 inch
wrench or socket..
7. PUt a comer bracket in each corner of the
shelf. (Figure 48)
Long End Of Shelf
Long End Of Shelf
o
Corner Bracket
Fig. 48
8. Put two truss head bolts through the shelf
and each comer bracket to hold the brackets
in place. Only put bolts through holes in the
long edges of the shelf, not the narrow ends,
as shown. (Figure 48)
9. Put a lockwasher and hex nut on each bolt
and tighten using a 7/16 inch wrench or
socket.