Craftsman 113.198411 Operator's Manual page 17

Rear
Right Side
Panel
Shelf
Front
Fig. 38
16. Put a lockwasher and hex nut on the bolt
and hand-tighten.
17. Repeat steps 15 - 16 on the left side of
the shelf.
18. Unlock the levers on the foot assemblies.
19. Turn the cabinet upside down so that the
leveling feet and wheels are pointing up.
20. Put a spacer between the shelf and the
right foot assembly.
21. Put a truss head bolt through the foot as-
sembly, spacer, and shelf to hold the spacer in
place. (Figures 39 & 40)
1/4-20xl _-----_._ Spacer
Shelf
Fig. 39
17
Fig. 40 - Truss Head Bolt
22. Put a lockwasher and hex nut on the bolt
and tighten using a 7/16 wrench or socket.
23. Repeat steps 20 - 22 with the left foot as-
sembly.
24. Turn the cabinet back over onto the
wheels.
25. Move the cabinet to the location where
you will use your saw and push down on foot
levers to lock leveling feet in place.
_1_ WARNING: Saw blade can roll
forward toward you if the leveling feet are
not correctly adjusted. Workpiece or saw
can move unexpectedly if cabinet rocks.
Fingers, hand or arm can be cut off from
blade contact. Adjust leveling feet before
using your saw so arm slopes to the rear.
26. If the leveling feet lift the front two wheels
slightly off the floor and the cabinet does not
rock, go to step 28, or
If the leveling feet do not lift the front two
wheels off the floor, or
If the cabinet rocks, go to step 27.
27. Loosen the the hex nut on each leveling
foot and rotate until the front wheels are
slightly off the floor or until the cabinet does
not rock. Then tighten the hex nuts using a
9/16 inch wrench.
28. Put the last rear support in front of you
with the long tabs down, short tabs up and
solid surface facing you. Attach two slide
brackets to each side of this rear support using
four truss head bolts. Attach these slide brack-
ets to the holes shown in the figure. Make