Attaching Casters/Building Foot Assemblies - Craftsman 113.198411 Operator's Manual

6. Put truss head bolts through the eight
holes indicated. Put a lockwasherand hex nut
on eachbolt tighten using a 7/16 inch wrench
or socket.
7. Put a
comer bracket in each corner of the
shelf (Figure 19)
Long End Of Shelf
Long End Of Shelf
_r Bracket
Fig. 19
8. PUt two truss head bolts through the shelf
and each comer bracket to hold the brackets
in place. Only put bolts through holes in the
long edges of the shelf, not the narrow ends,
as shown. (Figure 19)
9. PUt a lockwasher and hex nut on each bolt
and hand-tighten.
Attaching Casters / Building Foot Assemblies
The following parts are used in the caster and
foot assemblies for model 113.198611:
A.
B.
C.
D.
E.
G°
H.
I.
J.
K.
L.
Casters .......................... 4
Actuator Boxes ................... 2
Levers ........................... 2
Rods ............................ 2
Retaining Plates .................. 2
Grooved Pins ..................... 2
Smooth Pins ...................... 2
Washers ......................... 2
Springs .......................... 2
Hex Nuts 3/8-16 .................. 2
Leveling Feet ..................... 2
Phillips Head Screws 10-32x3/8 ..... 4
C
Fig. 20 - Parts for Caster / Foot Assembfies
1. Put the casters" (wheels) on the shelf and
comer brackets. Since the shelf is upside
down, the wheeL_ will point up. Line up four
holes in each corner. (Figure 21)
Corner Bracket_
Shelf
Caster (Wheel)
Fig. 21
2. Put bolts through the four holes in each
corner. Put a lockwasher and hex nut on each
bolt and tighten using a 7/16 inch wrench or
socket.
3. Separate all of the parts for the foot as-
semblies into two groups. There are two sets
12