Mounting Doors - Craftsman 113.198610 Owner's Manual

MOUNTING DOORS FOR
MODEL NO. 113.198410
1. Slide the upper support into the top of the center
support so the top and side holes line up. Then
assemble to the front and rear skirts with four (4)
1/4-20 x 1/2 truss head bolts, Iockwashers, and
hex nuts. Position bolts from bottom side with
threads upwards on front skirt as illustrated.
Tighten hex nuts securely.
2. Assemble the front support to the lower and the
upper supports with four (4) 1/4-20 x 1/2 truss
head bolts, Iockwashers, and hex nuts.
NOTE: It may be necessary to tilt the stand
backwards to tighten the bolts holding the center
support to the lower support.
E=r
t,e _
3. Locate the four (4) door hinges and eight (8)
plastite screws 10-14 x 1/2. Lay out doors on
floor side by side to establish left and right side.
Mount hinges on outside edge with phillips
screwdriver.
_ HINGES
_/ MAGNETIC CATCH
_r
DOORS
4. Locate the two (2) magnetic catches, two (2)
magnetic stop plates, four (4) pan head screws
6-19 x 1/2, and four (4) pan head screws 6-32 x
3/8. Attach a magnetic catch to each door with
two (2) pan head screws 6-19 x 1/2, using a
Phillips screwdriver. Then on each side of the
center support, attach a magnetic stop plate with
two (2) 6-32 x 3/8 pan head screws, using a
Phillips screwdriver.
5. Locate eight (8) truss head bolts, Iockwashers
and hex nuts to attach door hinges to the side
panels. Tighten hex nuts with a 7/16" wrench or
socket. Adjust stop plate if necessary with phillips
screwdriver for desired closure.
CENTER
SUPPORT _
O
o
o
MAGNETIC
STOP PLATE
SCREW
"_ _ 6-32 x3/8
23