Procedures Required For An Appletalk Network - Canon imagePROGRAF W2200S User Manual

Procedures Required for an AppleTalk Network

1
2
3
4
Important
Note
3-2
AppleTalk Network Settings (Macintosh)
Here is a summary of the procedures required to set the printer for use on an
AppleTalk network.
Connect the Network Cable
Follow the instructions in the Setup Guide to connect the network cable.
Setting a Macintosh
Confirm the network settings for the Macintosh.
Setting the Printer Protocols
Normally, the printer can be used with AppleTalk protocol without any changes. Use the Web
browser to select the name and zone settings after entering the IP address with the printer
operation panel.
Installing the Printer Driverr
Install the Macintosh printer driver.
z Steps 1 and 3 above should be performed by the network system administrator.
z This section describes the printer connection to a Macintosh computer equipped
with a standard Ethernet port built in. If the printer is connected to an expansion
network interface board, be sure to select the name of the port.
ÆSetup Guide
ÆP.3-3
ÆP.3-5
ÆP.3-10