Table of Contents
Advertisement
Setting the Printer Protocols
Use the Web browser (Remote UI) from your computer to perform the
protocol settings. To perform the settings, first enter the IP address with the
printer operation panel, then use the Web browser to set the protocol.
(Æ Setup Guide)
1
Start the Web Browser, enter the following URL for the Address, then
press the Enter key.
http://<Printer IP address or name>/
Example: http://XXX.XXX.XXX.XXX/
Important
z For the Web Browser, use Netscape Navigator/Communicator 4.04 or later, or use
Internet Explorer 4.01SP1 or later. However, Netscape Navigator Version 6 or later
is not compatible.
z A connection through a Proxy Server cannot be used. If you are using a network
environment with a Proxy Server, use the "Proxies" server setting in the Web
Browser to add the printer IP address to the "Exceptions" text box (the address not
used by the Proxy Server). (Performing this setting may differ, depending on the
network environment.)
z Use the Web Browser to enable JavaScript and Cookie so these features can be
used.
z If more than one Remote UI is being used, then the most recently used settings
remain enabled. Starting and using only one Remote UI at a time is recommended.
Note
z If you have started the Remote UI with the printer name, confirm that the DNS
environment and the board DNS settings are executed correctly.
3-5
Setting a Macintosh
Advertisement
Table of Contents
