Table of Contents
Advertisement
5
6
Note
7
4-14
®
NetWare
Settings (Windows)
Check the Frame Type box and make sure the setting is correct for
®
your NetWare
network.
If you intend to use the burst mode, select ON for NCP Burst Mode.
z The burst mode is used in the queue server mode to transfer data rapidly at very
high speed during printing.
z Normally, leave this setting on.
Perform the following procedure requred for your print service
selection.
z Bindery PServer selected: Queue Server Mode (Using a Bindery Print
Server)
For Print Server Name, enter the name of the print server
created in "Setting NetWare
®
For NetWare
Set value for Polling Interval. Set the interval that the printer will
confirm with the NetWare
®
Print Service" (Æ P.4-6).
Server Name x, enter the file server name.
®
print queue.
Advertisement
Table of Contents
