Table of Contents
Advertisement
Before connecting the saw to power, read through
section on
to verify that your setup
follows the safety and circuit requirements for this
machine.
Open the power connection box shown in
.
Power
Connection Box
Power connection box.
Connect the power wires to the terminals shown in
, tighten the strain relief so the wires can't be pulled
from the terminals, then close the power connection box.
Ground
S
R
Figure
. Power connection terminals.
Once the assembly is complete and the power source is
connected, test run your machine to make sure it runs
properly and is ready for regular operation.
The test run consists of verifying the following: 1) The
ON Button
motor powers up and runs correctly, 2) the stop button
safety feature works correctly, and 3) the safety limit
switches work correctly.
If, during the test run, you cannot easily locate the source
STOP Button
of an unusual noise or vibration, immediately stop using
the machine, then review
on
.
If you still cannot remedy a problem, contact our Tech
Support at (360) 734-3482 for assistance.
Before beginning the test run, review the power controls
shown in
and
on
.
Main power controls.
-28-
Advertisement
Table of Contents
