Shop fox W1811 Owner's Manual page 23

10" sliding table saw
Hide thumbs Also See for SHOP FOX W1811:
Table of Contents

Advertisement

Place a 12mm flat washer on the crosscut table
lock lever, then insert it through the crosscut
Lock Lever
fence and thread the M12-1.75 T-nut onto the end
approximately two turns.
Align the T-nuts on the crosscut table with the
T-Slot
T-slot in the face of the sliding table, then slide
the crosscut table into position on the sliding table
(
) and tighten the crosscut table lock lever.
T-Nut
Crosscut table installation.
Place the crosscut table support leg on the extension
Attachment
arm, and attach it to the crosscut table with four
Location
M6-1 x 16 cap screws, 6mm lock washers, and 6mm
flat washers.
Support Leg
Extension
Arm
Support leg installed.
Insert the two crosscut brace knobs with 8mm flat
washers through the crosscut table, then thread
the square nuts onto the ends of the knob threads
(
). Slide the T-slot in the support bar
over both T-nuts, and tighten the knobs (
).
Installing support bar on
crosscut table.
-21-

Advertisement

Table of Contents
loading

Table of Contents