Shop fox W1811 Owner's Manual page 26

Thread the feet all the way into the bottom of the
support legs. DO NOT remove the hex nuts pre-
installed on the bottom of the feet, since they will
be used after the legs are installed.
Thread two M10-1.5 x 30 cap screws and 10mm lock
washers through each support leg and part way into
the T-slot plates for the legs, slide the T-slot plates
into the both ends of the sliding table base, and
tighten the mounting cap screws (see
Adjust the feet downward so they press against the
floor, then tighten the hex nuts up against the sup-
port leg so the feet are locked in place.
Open the cabinet door and remove the motor ship-
ping brace shown in
Tilt the blade assembly to 0˚, then slide the slid-
ing table forward all the way until you can open
the lower blade guard cover and access the blade
arbors.
Insert the arbor lock tool into the hole shown in
, rotate the arbor until the arbor lock tool
seats, then install the main blade, using the included
arbor wrench to loosen and tighten the arbor nut
(the arbor nut has left-hand threads and loosens
clockwise). There MUST be an arbor flange between
the blade and the arbor nut.
Insert the arbor lock tool into the hole shown in
, rotate the arbor until the arbor lock tool
seats, then install the scoring blade, using the arbor
wrench. There MUST be an arbor flange on both
sides of the blade.
).
.
-24-
Support Leg
Support leg installed (1 of 2
shown).
Motor shipping brace.
Arbor
Lock
Tool
Installing main blade.
Arbor
Lock
Tool
Installing scoring blade.