Kyocera TASKalfa 650c Printing Manual page 118

3 PRINTING FROM Macintosh
Finishing
In the Finishing menu, you can set the destination, hole punching and stapling.
1
2
3
1) Destination
This selects the destination tray.
- Printer's Default — Select this to route the output to the default tray (that is set as the default tray for raw job in the
Printer setting page of COMMAND CENTER Administrator's page).
- Upper Exit Tray — Select this to set the output to the upper exit tray of this equipment.
- Side Exit Tray — Select this to set the output to the side exit tray of this equipment.
- Tray 1 — Select this to set the output to the upper tray of the Finisher (optional).
- Tray 2 — Select this to set the output to the lower tray of the Finisher (optional).
– Depending on the type of Finisher (optional) installed and destination settings, stapling and hole punching may
not be performed.
– Depending on the equipment settings, the paper may be delivered to a tray that cannot carry out stapling or
hole punching when [Printer's Default] is selected as the [Destination] option.
– [Tray 1] and [Tray 2] can be enabled when the Finisher (optional) or Saddle Stitch Finisher (optional) is
installed.
– [Side Exit Tray] can be enabled only when neither of the Finisher (optional) and the Saddle Stitch Finisher
(optional) is installed.
2) Hole Punch
This sets whether or not a print job is hole punched.
- Off — Select this to print without hole punches.
- Long Edge Punch without rotation — Select this to create holes on the left side for a portrait document, or on the
top for a landscape document.
- Short Edge Punch without rotation — Select this to create holes on the top for a portrait document, or on the
right for a landscape document.
116 Printing from Application on Mac OS X 10.2.4 to Mac OS X 10.5.x