Hole Punching - Kyocera TASKalfa 650c Printing Manual

2.PRINTING FROM WINDOWS
¦ Stapling
You can staple sets of paper to exit from the equipment.
Stapling is not available if a Finisher (optional) is not installed.
Stapling the paper
Display the [Finishing] tab menu.
1
Select the [Staple] check box. Select a stapling option.
2
Upper Left — Select this to staple the printed document at the upper left.
Upper Right — Select this to staple the printed document at the upper right.
Center Top — Select this to double staple the printed document along the top edge.
Middle Left — Select this to double staple the printed document along the left side.
Center Double — Select this to fold and double staple the printed document in the center.
– The selectable options vary depending on the paper size.
– [Center Double] can be selected only when the Saddle Stitch Finisher (optional) is installed and configured
on the [Configuration] tab.
3 Set any other print options you require and click [OK].
Click [OK] or [Print] to send the print job.
4
The output is stapled for each copy.
¦ Hole punching
Select this to punch holes on printed sheets of paper to exit from the equipment.
Hole punching is not available if a Hole Punch Unit (optional) is not installed.
Punching holes
Display the [Finishing] tab menu.
1
2 Select the [Hole Punch] check box. Select a hole punch option.
Center Top — Select this to punch holes along the top edge.
Middle Left — Select this to punch holes along the left side.
3 Set any other print options you require and click [OK].
Click [OK] or [Print] to send the print job.
4
Holes are punched.
2 PRINTING FROM WINDOWS
Printing with Best Functions for Your Needs 73