Adjusting The Platen Gap For Heavy Stock - Epson Pro 9000 Printer Manual

1-20 | Handling Paper and Other Media
Caution
To avoid damaging the
printer, never move the
paper set lever while the
Operate or Pause light
is flashing.
6. Push the paper set lever all the way down, then close the lower cover.
PRESS PAUSE BUTTON
7. Press the button. The print head moves and the board feeds into
Pause
printing position automatically.
(Even if you don't press
printing position automatically after 10 seconds.)
8. Run your print job. After it is finished, the posterboard stays in the
printer.
9. To remove the print, hold it and pull the paper set lever all the way up.

Adjusting the Platen Gap for Heavy Stock

When you print on heavy stock, you may need to adjust the platen gap
setting. Normally, the
automatically. However, if print quality is not satisfactory when you use
heavy stock, change this setting to
1. Press the
SelecType
the display.
2. Press the button.
Item
3. Press the button.
+
1-20
appears on the control panel display.
READY
, the board and printer will move into
Pause
setting allows the printer to adjust
AUTO
Follow these steps:
WIDE.
button.
PRINTER SETTING MENU
PLATEN GAP=AUTO
PLATEN GAP=WIDE
appears on the control panel.
appears on
appears on the display.
appears on the display.