Epson Pro 9000 Printer Manual page 100

5. Secure the interface card in the slot with the two screws included with
the card.
6. Make sure the printer has been turned off using the
Then plug in the power cord.
7. To initialize the EpsonNet Internal Print Server, turn on the printer
while holding down the status sheet button on the card for about
5 seconds.
8. Connect the appropriate cable to the card and to your network hub or
computer.
To remove an interface card, turn off the printer, unplug the power cord,
and follow the above steps in reverse order.
Before you can use the EpsonNet Internal Print Server, you must configure
it for your network protocols and operating system. See the EpsonNet
Internal Print Server Administrator's Manual for instructions.
Before you can print, you must install the printer software, as described on
page B-3 (Macintosh) or page C-2 (Windows).
A-3
Installing an Interface Card
Power
| A-3
button.