Assembly - Grizzly g0703 Owner's Manual

assembly

to assemble the dust collector:
1.
invert the stand, place a
each of the four caster wheel studs. then
thread each caster into the stand, and using a
⁄ " wrench, tighten each caster stud onto the
3
8
stand (see figure 13).
x 4
figure 13. Stand and caster wheels.
2. rotate the stand to the upright position.
3. Secure the h-supports and upper stand rails
to the stand, as shown in figure 14, using
(16) ⁄ "-18 x ⁄ " hex bolts and (16)
5 3
16 4
washers.
rail
h-Support
figure 14. installing stand rails.
-18-
⁄ " lock washer on
3
8
⁄ " flat
5
16
x 16
Stand
4. position the stand over the dust collector
housing, as shown in figure 15, and install
(1) ⁄ "-18 x 1 ⁄ " hex bolt and flat washer on
5 1
16 2
each side of the stand to serve as pivot bolts
(leave bolts loose for now).
pivot Bolt location on Both Sides
figure 15. pivot bolt installed.
5.
With the help of an assistant, carefully lay
the dust collector on its side, and line up the
stand with the remaining six mounting holes.
6.
install the remaining (6)
bolts and (6) ⁄ " flat washers, then tighten all
5
16
hex bolts (see figure 16).
figure 16. dust collector and stand positioning.
7.
With the help of an assistant, lift the stand
and dust collector assembly upright into
place.
Model g0703/g0703p (Mfg. Since 3/12)
⁄ "-18 x 1 ⁄ " hex
5 1
16 2
three Bolts
on
Both Sides