Assembly - Grizzly G0849 Owner's Manual

Assembly

The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
To assemble machine:
1.
Install (3) 3" non-locking swivel casters to
base stand using (12)
" flat washers (see Figure 9).
and (12) ⁄
1
4
Figure 9. Non-locking swivel casters installed.
2. Install (2) 3" locking swivel casters to base
stand using (8) ⁄ "-20 x
1
4
⁄ " flat washers (see Figure 10), then place
1
4
base stand on casters.
Figure 10. Locking swivel casters installed.
-16-
⁄ "-20 x ⁄ " hex bolts
1 3
4 4
x 12
⁄ " hex bolts and (8)
3
4
x 8
3.
Position lower front legs in base stand with
flanges facing inside and two threaded bolt
holes above, as shown in Figure 11.
4.
Secure left and right lower front legs to base
stand using (2) ⁄ "-18 x
5
16
" fender washers per leg (see Figure 11).
⁄
5
16
Finger-tighten for now.
Bolt
Holes
Above
Flange
Flanges
Face
Inside
Front
Figure 11. Lower front legs installed.
5. Attach (2) rear legs (36" long) to base stand
with (2) ⁄ "-18 x
5
16
fender washers per leg (see Figure 12).
Finger-tighten for now.
Figure 12. Rear legs attached to base stand.
Model G0849 (Mfd. Since 01/19)
⁄ " hex bolts and (2)
3
4
Left Right
Leg Leg
x 4
⁄ " hex bolts and (2)
3
4
Rear
Legs
x 4
⁄ "
5
16