Removing A Memory Module; Rom Module; Installing A Rom Module - Epson EPL-N2010 Reference Manual

Removing a memory module

1. Perform steps 1 through 7 in the previous section to access the
printer's RAM slots.
2. Pull the clips on each side of the RAM slot outward to release
the memory module.
3. Grasp both sides of the DIMM and pull it out as shown above.
4. Follow steps 12 through 15 in the previous section to complete
the procedure.

ROM Module

Installing a ROM Module

You can install the Adobe PostScript 3 kit (C83234 ) using the
same basic steps as those used to install the memory module.
1. Perform steps 1 through 7 in "Installing a memory module"
section to access the printer's RAM slots.
2. Make sure the printer has three ROM slots. The left ROM
(PROG slot) slot should be already in use. You should install
the PostScript board in the center ROM slot (A slot).
3-18
Options