Using The Postscript Printer Driver With Windows; Installing The Postscript Printer Driver For The Parallel Interface - Epson AcuLaser C9200 Series User Manual

Note:
To use binary data, Epson recommends that you use AppleTalk for the printer's network connection.
If you use a protocol other than AppleTalk for the network connection, you need to set Binary to On
in the PS3 Menu on the control panel. If you use the printer with a local connection, you cannot use
binary data.

Using the PostScript Printer Driver with Windows

To print in the PostScript mode, you will have to install the printer driver. See the appropriate sections
below for installation instructions according to the interface that you are using to print.

Installing the PostScript printer driver for the parallel interface

Caution:
c
Never use EPSON Status Monitor and PostScript 3 driver at the same time when the printer is
connected via a parallel port. It may damage the system.
Note:
❏ Installing the printer software for Windows Vista, Vista x64, XP, XP x64, or 2000 may require
administrator privileges. If you have problems, ask your administrator for more information.
❏ Turn off all virus protection programs before installing the printer software.
1. Make sure that the printer is turned off. Insert the printer software CD-ROM into your CD-ROM
drive.
2. For Windows 2000, click Start, point to Settings, and click Printers. Then double-click the
Add Printer icon.
For Windows Vista, Vista x64, XP, click Start, point to Printer and Faxes, and click Add a
printer in the Printer Tasks menu.
3. The Add Printer Wizard appears. Then click Next.
4. Select Local printer, then click Next.
Note:
Do not select the Automatically detect and install my Plug and Play printer check box.
5. Select LPT1 as the port the printer is connected to, then click Next.
EPSON AcuLaser C9200 Series
About the PostScript Printer Driver
User's Guide
240