Table of Contents
Advertisement
❏ When removing the photoconductor unit, do not expose it to sunlight at all and avoid exposing
it to room light for more than five minutes. The photoconductor unit contains a light-sensitive
drum. Exposure to light can damage the drum, causing dark or light areas to appear on the printed
page and reducing the service life of the drum. If you need to keep the photoconductor unit out
of the printer for long periods, cover it with an opaque cloth.
❏ Be careful not to scratch the surface of the drum. When you remove the photoconductor unit
from the printer, always place it on a clean, smooth surface. Avoid touching the drum, since oil
from your skin can permanently damage its surface and affect print quality.
❏ To get the best print quality, do not store the toner cartridge or photoconductor unit in an area
subject to direct sunlight, dust, salty air, or corrosive gases (such as ammonia). Avoid locations
subject to extreme or rapid changes in temperature or humidity.
❏ Be sure to keep consumable components out of the reach of children.
❏ Do not leave jammed paper inside the printer. This can cause the printer to overheat.
❏ Avoid sharing outlets with other appliances.
Important Safety Instructions
Read all of the following instructions before operating your printer:
When choosing a place and power source for the printer
❏ Place the printer near an electrical outlet where you can easily plug in and unplug the power cord.
❏ Do not place the printer on an unstable surface.
❏ Do not put your printer where the cord will be stepped on.
❏ Slots and openings in the cabinet and the back or bottom are provided for ventilation. Do not
block or cover them. Do not put the printer on a bed, sofa, rug, or other similar surface or in a
built-in installation unless proper ventilation is provided.
❏ All interface connectors for this printer are Non-LPS (non-limited power source).
❏ Connect all equipment to properly grounded power outlets. Avoid using outlets on the same
circuit as photocopiers or air control systems that regularly switch on and off.
❏ Connect your printer to an electrical outlet that meets the power requirements of this printer.
Your printer's power requirements are indicated on a label attached to the printer. If you are not
sure of the power supply specifications in your area, contact your local power company or consult
your dealer.
EPSON AcuLaser C9200 Series
Safety Instructions
User's Guide
16
Advertisement
Table of Contents
