Epson AcuLaser C9200 Series User Manual page 117

EPSON AcuLaser C9200 Series User's Guide
To clear this error, select Clear Warning from the control panel's Reset Menu. For instruction
about accessing the control panel menus, see "How to access the control panel menus" on page 79.
Reset
The printer's current interface has been reset and the buffer has been cleared. However, other
interfaces are still active and retain their settings and data.
Reset All
All printer settings have been reset to the default configuration, or to the last settings that were saved.
Reset to Save
A control panel menu setting was changed while the printer was printing. Press the Start/Stop button
to clear this message. The setting will become effective after printing has finished.
Alternatively you can clear this message by performing Reset or Reset All on the control panel.
However, the print data will be deleted.
ROM CHECK
The printer is checking the ROM.
SELF TEST
The printer is currently performing a self test and initialization.
Service Req Cffff/Service Req Exxx
A controller error or a print engine error has been detected. Turn off the printer. Wait at least 5
seconds, then turn it back on. If the error message still appears, write down the error number listed
on the LCD panel (Cffff/Exxx), turn off the printer, unplug the power cord, then contact a qualified
service representative.
Set Release Lever to ppp Position
The position of the release lever is incorrect. Open cover A and cover B, change the release lever
position to ppp, and then close cover B and cover A. (The position Normal or Envelope appears in
place of ppp.)
Sleep
Using the Control Panel 117