Epson AcuLaser C9200 Series User Manual page 115

EPSON AcuLaser C9200 Series User's Guide
There is a problem with the photoconductor unit of the indicated color. Remove the photoconductor
unit and reinsert it. If that fails to clear the error, replace the photoconductor unit. To install the
photoconductor unit, see "Photoconductor Unit" on page 165.
Photocon uuuu Needed Soon
This message indicates that the photoconductor unit of the indicated color is near the end of its
service life. You can continue to print until the Replace Photocon uuuu message appears.
Please wait for print
Printing cannot start because the previous job is being processed. Try again after a few seconds.
Print Overrun
The required time to process the print data exceeded the print engine speed because the current page
is too complex. Press the Start/Stop button to resume printing, or press the + Cancel Job button
to cancel the print job. If this message appears again, select On as the Page Protect setting in the
control panel's Setup Menu or select Avoid Page Error on the printer driver.
If you continue to receive this message when printing a particular page, try simplifying the page by
limiting the number of graphics or reducing the number and size of fonts.
To avoid this error, it is recommended that you set the Page Protect setting to On and add more
memory to the printer. See "Setup Menu" on page 87 and "Memory Module" on page 150 for details.
PS3 CompactFlash Full
The memory allocated for writing PostScript 3 commands on the optional CompactFlash memory
is full.
To clear this error, select Clear Warning from the control panel's Reset Menu. For instruction
about accessing the control panel menus, see "How to access the control panel menus" on page 79.
RAM CHECK
The printer is checking the RAM.
Ready
The printer is ready to receive data and print.
Replace Feed Roller C2, Replace Feed Roller C3, Replace Feed Roller C4
Using the Control Panel 115