Autodial - Toshiba PERCEPTION 4000 User Manual

PERCEPTION 4000
4. Dial the destination number or
enter the desired feature
access code.
To Program an Autodial Key:
1. Press the Program Mode
(PRGM) access key.
NOTES:
1. Display telephones will display "AUTH CODE" after pressing the
AUTH key or entering the Authorization Code access code. The
telephone will not display the authorization code itself when the code
is entered.
2. Authorization code allowances will remain in effect for the duration of
the call. Once an authorization code has been applied to a line, no
other authorization codes can be applied to the line or any of the
station's other line appearances, until the call is completed.
3. An entered authorization code applies only to the line to which it has
been applied. Other line appearances on a dialing telephone retain
their original calling restrictions.
4. If a station establishes a call via the use of an authorization code
and later uses either Three-way Calling or the Call Hold feature, the
authorization code's allowances will still apply to the line used to
place the call.
5. If a call made through the entrance of an authorization code is
camped-on to a busy destination, the authorization code will be
applied during a camp-on callback. The authorization code
allowances will not be in effect during the time interval between the
station hang-up and the camp-on callback.

AUTODIAL

You can program each of your telephone's Autodial keys so that a
directory number, station number, trunk access code, or account code
will be automatically dialed whenever the key is pressed. Line selection
can be programmed into the Autodial sequence so that the preferred line
will be automatically accessed before the programmed number is dialed.
An Autodial key that is programmed to call a station can be specified to
perform a voice call to the station. Autodial keys can be used during the
same call to dial different parts of the desired number or code. The
programming of Autodial keys takes place in the telephone's Program
Mode.
The PRGM LED will light solid red.
FEATURE OPERATION
4-5