Container Assembly; Container Mounting - Craftsman 917.249890 Owner's Manual

CONTAINER ASSEMBLY (See Fig. 3)
1. Place bottom half inside of top half, as shown.
2. Place one foot inside bottom half and lifttop half to meet
bottom half.
3. Press halves tightlytogether while liftingtop to lock into
place as shown.
IMPORTANT: BEFORE LOCKING THE TABS, HOOKED
EDGES ON BOTH HALVES MUST OVERLAP TO FORM
SEAL AS SHOWN IN INSET.
4. Repeat for other containers.
CONTAINER
BOTTOM
HALF
NER
TOP
CONTAINER
BOTTOM
HALF
PRESS TOGETHER
TO FORM SEAL
WHILE LIFTING
TOP HALF
LOCKING
TAB
ASSEMBLY CHECK: Squeeze sides of lower half of con-
tainer and check that there is no gap between upper and
lower halves. If a gap appears, unlock tabs to separate
container halves and repeat instructions above.
FIG. 3
CONTAINER MOUNTING (See Fig. 4)
1. Install one container to left side first with warning to
outside of unit. Install another container to center
position and one in right position.
NOTE: Right container should always overlap left container
at center supports.
2. Close cover and lock latch handles over center support
tubes.
COVER LATCH
HANDLES
i,' ,
CONTAINER
WARNING
CENTER
TUBES
CONTAINER
HANDLE
CONTAINER
WARNING
FIG. 4